Full Overlay Panel Installation Instructions - AGA marvel ML15CR Installation, Operation And Maintenance Instructions

FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS

CAUTION
!
Step 1: Verify door alignment
Verify that the door is aligned correctly with the cabinet
prior to fabricating the custom panel. Failure to do so may
result in mis-alignment of the custom panel with the hinge
bracket. The door should be parallel to the sides and top of
the refrigerator. If alignment is necessary the door may be
adjusted by loosening the 2 screws which secure the top
and/or bottom hinge adapter brackets, located on the top
and bottom of the door and adjusting the door side to side.
Use a ⁄ " allen wrench, for this procedure. (See Figure 15
5
32
below). When finished aligning the door, tighten the screws
securely.
Hinge adapter bracket
located on the top and
bottom of the door.
Figure 15
Remove top
hinge pin to re-
move the door.
⁄ "
9
32
(7mm)
Door should be
parallel to top
and sides of
ice machine.
Step 2: Remove door
Remove the top hinge pin from the hinge with an
wrench. Remove the door by angling the top of the door
outward and lifting the door off the bottom hinge.
(See detail in Figure 15).
Step 3: Remove gasket
Lay the door on its front being careful not to scratch it. To
gain access to the screw holes remove the door gasket by
peeling up and out of the channel.
Step 4: Cut overlay panel
Depending on the ice machine model cut the overlay panel
to the dimensions shown in Figure 16.
NOTE
For overlay with lock option panel thickness to be
(19mm) maximum to ⁄
5
8
CAUTION
!
Weight of the overlay panel should not exceed 20 pounds
(9.1 kilograms).
NOTE
For the door to close properly, it is necessary to maintain a
minimum space of ⁄ " (7mm) between the door and cabi-
9
32
net flange (See Figure 15). This space can be adjusted by
adjusting the top and bottom hinge adapter brackets.
12
" (16mm) minimum.
⁄ " allen
1
8
⁄ "
3
4