Diagnostics; Service Mode - GE WSLP1500H0WW Technical Service Manual

Service Mode

To enter into Service mode on engineering models
"H0", press and hold Load Size, Process and Power
pad.
On engineering models "H1~H2", press and hold
Deep Fill, Process and Power.
All LEDs will turn on in initial state of entering
Service mode. Pressing the Start button will
To exit Service mode, press Power, then unplug the
washer, or go through all the tests below.
Test
Initial state upon entering Service
mode
Press Start 1 time
Press Start 2 times
Press Start 3 times
Press Start 4 times
Press Start 5 times
Press Start 6 times
Press Start 7 times
Press Start 8 times

Diagnostics

Service modes.
Item Checked
All LED's on. Water level frequency
checked with no water in the tub.
Laundry amount detection
Cold water valve
Hot water valve
Nothing tested
Drain/Mode shift motor engage
for agitate
Drain/Mode shift motor disengage
for spin
Drain pump on
– 19 –
NOTE: It is important to note that fault codes should
only be used to help identify components which
require testing.
Never replace a part based solely on an fault code.
The control can generate a false fault code if the
right conditions exist. Use the code only as a
reference and always check the component before
replacing.
Displayed
"88" will be displayed quickly.
Then the version number (07 for
HO, 10 for H1, 11 for H2.
Then 63 ~ 68 for the water level.
Numerous numbers will show
in the display which are the
electromotive force values. Value
range from 130 to 160 with no
load.
EP
00
54
55
56
57