Diagnostics Mode - GE Profile Technical Service Manual

L2 DIAGNOSTICS MODE
The new electronics pc board has an on board
diagnostics system. To place the washer in
the FIELD SERVICE MODE and EXIT the FIELD
SERVICE MODE, follow the sequence shown
below.
To ENTER Field Service
Diagnostics Mode
To Exit Field Service
Diagnostics Mode
BEGIN
FIELD SERVICE
MODE
The following steps are performed by turning
the cycle selector clockwise to the next click
(detent).
1.
2.
3.
4.
5.
6.
7.
8.
9.
All LED's light.
Model Code Identifier
Error Code Identifier (see Problem
Diagnostics
-
Error Codes.)
Hot water valve activation.
Cold water valve activation.
Slow speed dry agitation.
(NOTE: Being in either speed agitation
and holding the start button in for 2
seconds will require disable DRY
AGITATION and require FILLING WITH
WATER before agitation.
Fast speed Dry Agitation.
Pump Activation.
Spin Activation.
10
PRESSAND HOLD
I I
PRESSAND HOLD
THE START BUTTON THE STARTBUTTON
I
I I
LOSSOF
POWER TO
CONTROL
ROTATE THE CYCLE
IL-
ROTATE THE CYCLE
SELECTOR KNOB
SELECTOR KNOB
1800
1800
.
30 MIN.
TIMEOUT
RELEASESTART
I
FROM
BUTTON
START OF
MODE
FIELD SERVI
IDLE
.....-/
MODE