Cabinet Handle; Base Assembly - GE WSLP1500H0WW Technical Service Manual

Cabinet Handle

The handles on the right and left side of the cabinet
are used to assist with installation.
Handle Replacement
The top cover will need to be raised to access the
handle. Once the cover is raised, reach down on the
inside of the cabinet to the handle. Squeeze up on
the bottom side of the handle to release the tabs
and push it through the opening to the outside of
the cabinet.
Shown from inside.

Base Assembly

The base assembly is designed to carry the weight
of not only the washer but the weight of the water
and the load in it. Depending on if the washer is a
stationary or portable is whether or not it will have
leveling feet or wheels.
Wheel Replacement
1. Carefully lay the washer on its side.
2.
wheel and pry up, popping the wheel axel/pin
loose from the base assembly.
Reinstalling the wheel and axel is done by lining up
the axel/pin with the opening. Then put pressure on
it to pop it into position.
– 41 –