Advertisement
Installing the AL 200
Introduction
AL 200 Antenna
Connection
The Motorola AL 200 Multi-User Modem
This section explains how to:
• Make antenna and cable connections to the AL 200, and power it up—see the
"AL 200 Antenna Connection" section on page 1-7.
• Connect computers to the AL 200:
- To connect the AL 200 to each computer with a wireless Home RF adapter,
see the "Wireless Computer Connections" section on page 1-8
- To connect the AL 200 to one computer using a higher-rate Ethernet or
USB cable, see the "Wireline Computer Connections" section on page 1-10
Caution
Ensure that the AL 200 is disconnected from the power outlet during the cabling
procedure, until the step that instructs you to connect it.
To turn the AL 200 on or off, connect or disconnect the power cord at the wall outlet.
Do not disconnect using the connector at the back of the unit.
Do not operate a AL 200 with an object physically located on top. This may result in
damage to the product or injury to the person.
Use the AL 200 only with the appropriate Motorola power supply.
The AL200 has been certified as a mobile device as per FCC Section 2.1091. In
order to comply with the FCC RF exposure requirements the AL200 must only be
installed with approved antennas, and a minimum separation distance of 20 cm must
be maintained from the antenna to any nearby persons.
Follow these steps:
Steps to Connect the Antenna to the AL 200
Step
1
Unpack the AL 200 antenna.
2
Screw the antenna connector into the AL 200 antenna connector until it is
snug.
3
Adjust the antenna elbow joint so that the antenna is vertical when the AL
200 is right side up.
Installing the AL 200
Action
1-7
Advertisement
