Advertisement
Pinouts
Introduction
Ethernet Port
Connector
Ethernet Port
Coax Cable
Connector
USB Port
Connector
USB Port
Connector Pinouts
This appendix describes the connector pinout requirements for the Motorola AL 200
Multi-user Modem.
The Ethernet (ENET) port on the rear panel of the modem is an 8-pin modular
connector. The connector conforms to the IEEE standard for 10/100BaseT access as
defined in 802.3i.
This table describes the pinouts for the Ethernet port on the modem. For examples,
refer to the "Using the Ethernet Port" section on page B-3.
Pin
1
2
3
4-5
6
7-8
The coax cable connector uses the following pinouts:
• Center conductor — signal
• External conductor — ground
The universal serial bus (USB) connector on the rear of the modem is a standard
USB connector. The connector conforms to the USB specifications.
This table describes the pinouts of the USB port:
Pin
1
2
3
4
Signal
+Receive Data
-Receive Data
+Transmit Data
Not Used
-Transmit Data
Not Used
Signal
+ 5 V
Data Negative
Data Positive
Ground
Appendix B
Connector Pinouts
B-1
Advertisement
