Maintenance; Hardware Indicators; Fci Module Leds - ABB S800 I/O User Manual

8uhƒ‡r…Ã$ Hhv‡rhpr
$ Q…r‰r‡v‰rÃHhv‡rhpr
Please see the
$! Ch…qh…rÃDqvph‡‚…†
$! 8D' ÃA8DÃH‚qˆyrÃG@9†
The CI810 FCI has indicators for FAULT, RUN, POWER OK, one for each fieldbus
communication cable and optical ModuleBus communications. For color and
functions see
Uhiyr $  T‡hqh…qÃG@9†Ã‚Ã8D' ÃA8DÃH‚qˆyrÐv‡uÃU7' U7'
G@9ÃHh…xvt
F (Fault)
R (Run)
P (Power OK)
T1 (Traffic 1)
T2 (Traffic 2)
Tx (TB810/TB811)
Rx (TB810/TB811)
(1) The F-LED will switch on at power up, restart of the module or when the module goes to Error
state. At start-up the module will do a self test, if the self test has gone OK the module will switch
off the F-LED.
3BSE 020 925R101
Avryqiˆ†Ã8‚€€ˆvph‡v‚ÃD‡r…shprÃs‚…Ã6q‰h‡ÃAvryqiˆ†Ã
T'ÃDPÃBrr…hyÃDs‚…€h‡v‚ÃhqÃD†‡hyyh‡v‚ÃV†r…¶ †ÃBˆvqrÃ
Table 5-1. and the for the location see
8‚y‚…
Red
Green
Green
Yellow
Yellow
Yellow
Yellow
Trp‡v‚Ã$
Figure
9r†p…vƒ‡v‚
(1)
Fault in the module
Operational state
Internal power OK
Traffic on AF 100 cable 1
Traffic on AF 100 cable 2
Transmit data on the optical ModuleBus
Receive data on the optical ModuleBus
ÃV†r…¶†ÃBˆvqr
Q…r‰r‡v‰rÃHhv‡rhpr
5-1.
45