Backup/Restore Procedures; Load The Software Upgrade - ABB S800 I/O User Manual

Avryqiˆ†Ã8‚€€ˆvph‡v‚ÃD‡r…shprÃs‚…Ã6q‰h‡ÃAvryqiˆ†Ã
8uhƒ‡r…Ã$ Hhv‡rhpr
5.
6.
Now the FCI is cleared and ready for application programming.
$# 7hpxˆƒSr†‡‚…rÃQ…‚prqˆ…r†
$# G‚hqÇurÃ8D' ÃT‚s‡h…rÃVƒt…hqr
It is assumed that the PC communication port is COM1: and the diskette drive is A.
Q…‚prqˆ…r
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Start the file manager/NT Explorer
11. If the serial port you are using is:
Caution! If you see a need for changing setup_c*.pif, do not modify the existing one
but modify a copy of it, because after a modification under Windows NT it will not
run under Windows 3.x anymore.
52
Take away the power supply for a short moment.
Apply power and let the FCI restart -- waiting 45 seconds.
Switch the power off at CI810.
Set up an invalid Advant Fieldbus 100 address (90-99) at CI810 address
switch.
Disconnects the Advant Fieldbus 100 cable.
Switch power on at CI810 and wait 45 seconds.
Switch the power off at CI810.
Set the Station address on CI810 to a valid address (1 to 79).
Switch power on at CI810 and wait 45 seconds.
Connect the PC and the CI810 using a TK527 cable between the RS232 service
port on the CI810 and the COM1 port of the PC.
Start WINDOWS on the PC.
– COM1: double click a:setup_c1.pif
– COM2: double click a:setup_c2.pif
ÃV†r…¶†ÃBˆvqr
3BSE 020 925R101