Daily Inspection And Maintenance; Daily Inspection And Maintenance Table; Engine Fuel Level; Fuel Tank Cap - Snorkel ATB 50 Operator's Manual

At the start of each work day (or 8 hour shift), an
ATB 42/50 qualified operator must perform the
Daily Inspection and Maintenance as listed in the
table below.
The purpose of the Daily Inspection and
Maintenance is to keep the ATB 42/50 in proper
working condition and to detect signs of
malfunction at the earliest possible time.
The ATB 42/50 should be in the STOWED
POSITION and the Master Key Switch set to
OFF before you begin this inspection.

Daily Inspection and Maintenance Table

Item

Engine fuel level

Fuel tank cap

Engine oil level

Fuel leaks
Engine coolant level
Wiring harnesses
Battery terminals
Battery fluid level
Hydraulic oil level
Hydraulic oil leaks
Tires
Bolts and fasteners
Structural damage and welds
Lanyard anchor points
Platform gravity gate
Platform swinging gate (option)
Platform guardrails
Flashing lights (option)
Air filter
Charging system
Ground control switches and alarms
Level sensor
Emergency power
Platform control box switches and
alarms
Ground Fault Circuit Interrupt
Platform work lights (option)
Slide pads (ATB 50 only)
Axle unlocked alarm, tipover hazard light
Placards and decals
ATB 42/50 – 0161987

7. Daily Inspection and Maintenance

Defective parts and/or equipment malfunctions
jeopardize the safety of the operator and other
personnel, and can cause damage to the
machine.
DANGER
DO NOT operate an ATB 42/50 that is known
to be damaged or malfunctioning.
Repair all equipment damage or malfunctions,
before placing the ATB 42/50 into service.
Service Required
Look to see that the fuel tank is full
Check to see that the cap is tight
Check oil level (between dipstick lines)
Visually inspect (hoses and connections)
Check fluid level and radiator hoses
Visually inspect (installation, condition)
Visually inspect (no corrosion)
Check fluid level (1/4" or 6 mm below filler neck)
Visually inspect level (between lines on gauge)
Visually inspect (hoses, tubes)
Visually inspect (condition)
Visually inspect (condition)
Visually inspect (weld cracks, dents)
Visually inspect (condition)
Check condition and operation
Check condition and operation
Visually inspect (condition)
Visually inspect (operation)
Check condition (gauge)
Visually inspect (gauge)
Actuate and inspect for proper operation
Check operation
Check operation (causes correct motion)
Actuate and inspect for proper operation
Check operation
Check operation
Visually inspect for installation and boom wear marks
Actuate and inspect for proper operation
Visually inspect (installation, condition)
page 7 - 1
Courtesy of Crane.Market