Table of Contents
Advertisement
Deployment
Hardware configuration > Properties
Proceeding
Loadable protocol driver
Save
30
1.
Start after installation the parameter plugin "Point-to-Point- Communication, Param-
eter Assignment" from the properties dialog of the CP by the button [Parameter...].
2.
Set at "Protocol" the protocol you want. Depending on the selected protocol there is
the possibility to set the parameters for received data and interface.
3.
Please regard as long as the plugin is open the properties dialog of
the CP is blocked. The parameters are only transmitted to your
project if they were stored.
4.
For parameterization of the protocol click at
eters. More information about the protocols may be found at:
cation protocols' page 36
5.
Store the protocol specific parameters after changing them.
There is the possibility to extend the number of protocols of the parameter plugin by
means of loadable protocol drivers. More may be found at the description of the corre-
Ä Chap. 6 'Communication protocols' page 36
sponding protocol.
1.
After adjusting the protocol specific parameters the parameters should be stored
with 'File è Save' respectively with
ð The parameters are transferred to your project only if you store these before.
2.
The plugin is closed with 'File è Exit' and the CP properties dialog is again
released. Store your configuration with 'Station è Save and compile' within your
project.
3.
Transfer the configuration to your CPU.
and set the wanted protocol param-
Ä Chap. 6 'Communi-
.
HB130 | CP | 341-1CH01 | en | 18-40
VIPA System 300S
Advertisement
Table of Contents
