Properties - YASKAWA CP 341 Manual

VIPA System 300S

5.2.1 Properties

CP 341-1CH01
General
Addresses
Basic parameters
Parameters...
HB130 | CP | 341-1CH01 | en | 18-40
The properties of the CP may be accessed by a double click at the CP within your project
in the hardware configurator. The parameters of the VIPA CP 341 may be modified by the
registers in the following described. For parameterization the parameter plugin "Point-to-
Point Communication, Parameter Assignment" is necessary. This may be received from
Siemens. For installation you have to start it and follow the instructions.
n Short Description
– The short description with the information below is identical to the shown Informa-
tion in the "hardware catalog" window.
Order No.
n
– Here the order number of the Siemens CP 341 is displayed. For project engi-
neering of the VIPA CP 341-1CH01 the Siemens CP with order number 6ES7
341-1CH01-0AE0 is to be used.
n Name
– This displays the designation of the CP, which may be changed. If the designation
is changed, the new designation appears in your project in the configuration table.
n Comment
– In this part the purpose of the module may be entered.
n Inputs / Outputs
– By presetting a start address for the input respectively output area the beginning
of the address area of the CPU may be determined, which is mapped by the CP.
Here the CP occupies for input and output 16byte each. This value is necessary
for integration in the user program. Please note with the CP that the base address
for input and output are identical.
n Process image
– With the process image a consistent image of the process signal may be
accessed during the program cycle.
– If the field process image shows the entry "---" then the set address area is out-
side the process image. The entry "OB1-PA" indicates that the set address area is
within the process image.
n Interrupt generation / Reaction to CPU STOP
– Here the interrupt behavior of the module may be adjusted.
If "Yes" is set, diagnostics interrupt is activated.
The plugin for point-to-point parameterization may be opened by this button.
Please regard that the installation of the parameter plugin "Point-to-
Point-Communication, Parameter Assignment" is necessary. This may be
received from Siemens.
In the following the fundamental proceeding for deployment is described. More informa-
tion for installation and deployment may be found at the additional documentation from
Siemens.
Deployment
Hardware configuration > Properties
29