Connecting To A Computer - Sharp XV-Z21000 Operation Manual

Connecting to a Computer

Ensure that the computer is the last device to be turned on after all the connections are made.
Connecting to a Computer Using a DVI Cable
To DVI Digital output terminal
Note
• When connecting the projector to the video equipment in this way, select "Signal Type" in the "Options"
menu. See page 44.
Connecting to a Computer Using the DVI to D-sub Cable
To RGB output terminal
Note
• When connecting the projector to the video equipment in this way, select "Signal Type" in the "Options"
menu. See page 44.
• Refer to "Computer Compatibility Chart" on page 60 for a list of computer signals compatible with the
projector. Use with computer signals other than those listed may cause some of the functions not to work.
• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Sharp
Authorized Service Center or Dealer.
• Depending on the computer you are using, an image may not be projected unless the computer's external
output port is switched on. (e.g. Press "Fn" and "F5" keys simultaneously when using a SHARP notebook
computer). Refer to the specifi c instructions in your computer's operation manual to enable your computer's
external output port.
Downloaded From projector-manual.com Sharp Manuals
Computer
DVI cable
(sold separately: AN-C3DV)
Computer
DVI to D-sub cable
(supplied accessory)
To DVI terminal
To DVI terminal
-23