Switching The Input Mode; Adjusting The Volume; Displaying The Black Screen And Turning Off The Sound Temporarily - Sharp PG-D3010X Operation Manual

Image Projection (Continued)

Switching the Input Mode

Select the appropriate Input mode for the
connected equipment.
Press INPUT
INPUT list.
Use INPUT
/
mode, and use O/Q to select the
audio input terminal.

Adjusting the Volume

Press VOL +/– on the remote control
or –O/Q+ on the projector to adjust
the volume.
Note
• Pressing VOL–/–O will lower the volume.
• Pressing VOL+/Q+ will raise the volume.
• When the projector is connected to external
equipment, the volume level of the external
equipment changes in accordance with the
volume level of the projector. Set the projector's
volume to the lowest level when turning the
projector on/off or when changing the input signal.
• When you do not want to output the sound
from the projector's speaker while the
projector is connected to external equipment,
set "Speaker" in the "PRJ-ADJ1" menu to
"Off". (See page 50.)
Displaying the Black Screen
and Turning Off the Sound
Temporarily
Press AV MUTE on the remote control
or close the lens shutter to temporarily
display a black screen and turn off the
sound.
Note
• Pressing AV MUTE again will turn the
projected image back on.
• When you close the lens shutter, the projector will
be set to AV Mute mode and then the projector will
be turned off automatically after about 30 minutes.
30
/ to display the
to select the Input
On-screen display On-screen display
On-screen display On-screen display
INPUT buttons INPUT buttons
AV MUTE button AV MUTE button
VOL +/– (Volume) VOL +/– (Volume)
buttons buttons
O/Q buttons O/Q buttons