Air Outlet Selection - Toshiba RAS-B10U2FVG-E Service Manual

Item Operation flow and applicable data,etc
7. Air outlet
< How to change air outlet selection >
selection
1. Operate the air conditioner and select cooling or heating
mode.
(Air outlet selection can't be changed at standby mode.)
2. Push AIR OUTLET SELECT button on the unit operation
panel to change air outlet selection.
AIR OUTLET indication
Air outlet is contorolled as below.
< How to cancel to change upper-flow at Bi-flow setting in cooling >
1. Stop operation.
2. Push and hold AIR OUTLET SELECT button on the unit
operation panel over 10seconds (less than 20seconds).
3. After holding 10seconds, 4 beep sounds in heard and
TEMPERATURE indicator displays "1" for 5seconds.
Release AIR OUTLET SELECT button.
AIR OUTLET SELECT button
AIR OUTLET SELECT button
- 33 -
FILE NO. SVM-18048
Description
1. Purpose
2. Description
• In Cooling operation, only lower-flow
can't be selected.
• In Dry mode operation,bi-flow and
lower-flow can't be selected.
• In heating operation and bi-flow
setting, the air outlet is set only upper
flow for preventing cold draft when
the indoor heat exchanger sensor
temperature (TC) is lower than 33
degrees.
• In cooling operation and bi-flow
setting, the air outlet is set only upper
flow for pravinting the room from
overcooling when the room
temperature (TA) is nearing the setup
temperature.
This function can be cancelled to
change setting.