Toshiba RAS-B10U2FVG-E Service Manual page 50

4. DRY OPERATION (COOLING ONLY)
For dehumidification, a moderate cooling performance is controlled automatically.
1. Press MODE : Select Dry
2. Press MODE : Set the desired temperature.
Note: Dry Mode fan speed is set to Auto only.
5. Hi-POWER OPERATION
To automatically control room temperature and airflow for faster cooling or heating
operation (except in DRY and FAN ONLY mode)
Press HI-POWER : Start and stop the operation.
6. FLOOR WARMING OPERATION
Heating will operate with downward blowing only.
Temperature of air outlet will be higher than usual.
7. ECO OPERATION
To automatically control room temperature to save energy (except in DRY and FAN ONLY mode)
Press ECO : Start and stop the operation.
Note: Cooling operation; the set temperature will increase automatically 0.5 degree/hour for 4 hours
(maximum 2 degrees increase).
Heating operation; the set temperature will decrease.
8. TEMPORARY OPERATION
In case of the misplaced or discharged remote control
• Pressing the RESET button, the unit can start or stop
without using the remote control.
• Operation mode is set on AUTOMATIC
operation, preset temperature is 24°C
and fan operation is automatic speed.
9. TIMER OPERATION
Setting the ON Timer
1
Press ON : Set the desired ON timer.
2 Press : Set the timer .
SET
3 3
Press : Cancel the timer .
CLR
Everyday timer allows the user to set both the ON & OFF timers and will be activated on a daily basis.
Setting Everyday Timer
1
Press ON : Set the ON timer.
2
OFF
Press : Set the OFF timer.
· During the every day timer is activation, both arrows
Note:
· Keep the remote control in accessible transmission to the indoor unit;
otherwise, the time lag of up to 15 minutes will occur.
· The setting will be saved for the next same operation.
.
Setting the OFF Timer
Press OFF
Press
SET
Press
CLR
SET
3
Press
SET
Press
4
mark flashing.
( or
- 50 -
: Set the desired OFF timer.
: Set the timer.
: Cancel the timer.
.
button during the ( or )
are indicated.
)
FILE NO. SVM-18048