Demo Mode - Siemens EZ9**KZ series Instruction Manual

Problem
The cooking sensor indicator will not light up and the cooking
sensor is not responding.
The indicator on the sensor flashes twice. The battery in the cook-
ing sensor is almost flat. You may be interrupted the next time you
cook by the battery running out.
The indicator on the sensor flashes three times. The connection
to the cooking sensor has been broken.
The hob is unable to connect to your home network or the extrac-
tor hood. E7010
The operating voltage is incorrect and outside of the normal oper-
ating range. E9000/E9010
The hob is not connected correctly U400

Demo mode

If the symbol is shown on the display, demo mode
±
is active. The appliance does not heat up in demo
mode. Disconnect the appliance from the power
supply.Wait a few seconds before reconnecting the
appliance. Then deactivate demo mode in the basic
settings within 3 minutes of switching on the appliance.
Solution
Replace the 3 V CR2032 battery. See the section entitled ~ "Changing the
battery"
If this does not solve the problem, press and hold the symbol on the cooking sen-
sor for 8-10 seconds and then reconnect the cooking sensor to the hob. See the
section entitled ~ "Connecting the wireless temperature sensor to the control
panel"
If the problem persists, contact our technical after-sales service.
Replace the 3 V CR2032 battery. See the section entitled ~ "Changing the
battery"
Press and hold the symbol on the cooking sensor for 8-10 seconds and then
reconnect the cooking sensor to the hob. See the section entitled ~ "Connecting
the wireless temperature sensor to the control panel"
Switch the hob off and then on again.
If the message appears again, contact our technical after-sales service.
Contact your electricity supplier.
Disconnect the hob from the mains. Make sure that you have connected the hob
as shown in the circuit diagram.
Trouble shooting
en
49