Table of Contents
Advertisement
When you switch on the ventilation system, the
Note:
right-hand settings area is no longer available. You can
change the fan setting for the ventilation system in the
left-hand settings area.
Switching on the ventilation system
If the
and
Note:
I
o
the metal grease filter correctly.
The
and
symbols are available. The ventilation
I
o
system can be switched on.
Touch the
symbol.
I
1.
The ventilation system starts at fan setting
setting that is selected will be shown on the display
panel and in the left-hand settings area. The right-
hand settings area is not available.
Notes
– Heat settings cannot be changed while the
setting is being applied for the ventilation system.
– During a period of a few seconds, a fan setting
for the ventilation system can be selected. The
settings area can then be used for selecting the
heat settings again.
Select the required setting from the settings area.
2.
The setting that is selected will be displayed in the
left-hand settings area.
To set a different setting, touch the
3.
select the required setting from the settings area.
The setting that is selected will be displayed in the
left-hand settings area.
Switching off the ventilation system
If you want to switch off the appliance, touch the
symbol. If you only want to switch off the ventilation
#
system, proceed as follows:
Touch the
symbol.
I
1.
Select the
symbol in the settings area.
‹
2.
Touch the
I
symbol to switch to the setting area for
3.
the hob.
The run-on will start once the appliance has been
Note:
switched off (depending on the basic settings selected).
Intensive setting
Activate intensive mode if strong odours or large
amounts of steam are produced. In this mode, the
ventilation system briefly operates at maximum power. It
automatically switches back to a low setting after a
short time.
Switching on
Touch the
symbol.
I
1.
Touch the
symbol.
›
2.
symbols are not available, insert
ƒ
I
symbol and
The
symbol and the symbols in the left-hand settings
›
area will be lit.
Intensive mode is now activated.
After eight minutes, the appliance automatically
Note:
switches back to fan setting
. The
After a few seconds, the settings area for the heat
Note:
settings will be displayed again.
Switching off
Touch the
1.
In the next few seconds, slide your finger over the
2.
settings area until setting
displayed.
Automatic start
Depending on the basic settings selected, the following
options will be available once you have selected the fan
setting for a cooking zone:
The ventilation system will not start.
■
The ventilation system will start at the fan setting
■
selected by the sensor.
The ventilation will start at a specified fan setting.
■
Select the option you want to use in the basic settings.
The basic settings also offer the option to adjust the
sensitivity of the sensor. ~ "Basic settings"
on page 36
Automatic mode with sensor control
Switching on
Touch the
The optimum setting is set automatically using a sensor.
will be shown on the display panel.
'
Switching off
Touch the
The fan setting that was last selected by the sensor will
be shown on the display panel. Automatic mode is
switched off.
Operating the appliance
is shown on the display panel.
›
Š
.
symbol.
I
or another setting is
‹
symbol.
o
symbol.
o
en
15
Advertisement
Table of Contents
