Usb Cable Assembly - IBM System x3500 Service Manual

4. Remove the power supply or power supplies from the server.
5. Rotate the power-supply cage out of the way.
6. Disconnect the power-supply docking cable from the system board.
7. Using a Phillips screwdriver, remove the three screws that secure the
To install a new power-supply docking cable, complete the following steps:
1. Connect the power-supply docking cable to the system board.
2. Position the power-supply docking cable cage inside the server, aligning the
3. Secure the cage in the chassis using the three screws.
4. Lower the power-supply cage into place.
5. Install the power supply; then, connect the power cord and all external cables.
6. Install and lock the left-side cover.

USB cable assembly

To remove the USB cable assembly from the server, complete the following steps:
1. Read the safety information that begins on page vii and "Handling
2. Turn off the server and peripheral devices; then, disconnect the power cords
3. Unlock and remove the left-side cover and open the bezel.
4. Disconnect the USB cable from the system board.
5. Press down on the release latch on the top of the USB mounting bracket and
6. Lift the mounting bracket out and away from the server while you pull the USB
To replace the USB cable in the USB mounting bracket, complete the following
steps:
74
IBM System x3500 Type 7977: Problem Determination and Service Guide
docking-cable connector to the chassis and remove the docking cable and its
cage from the server.
screw holes with the holes in the chassis.
static-sensitive devices" on page 57.
and all external cables as necessary to replace the device.
rotate the top of the mounting bracket away from the server.
cable through the hole.