Table of Contents
Advertisement
12.0 Troubleshooting EPR-1460 Plate Roller
Table 2
Symptom
Machine doesn't
operate; rolls won't
move.
Cones are made when
trying to make
cylinders.
Workpiece is not
bending.
* WARNING: Some corrections may require a qualified electrician.
13.0 Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-
274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and Serial Number of
your machine available when you call will allow us to serve you quickly and accurately.
Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from JET.
Some parts are shown for reference only, and may not be available individually.
Possible Cause
No incoming power.
Emergency stop engaged.
Jam nut is loose.
Gears damaged.
Rolls not parallel.
Machine capacity exceeded.
Idler roll not engaging.
Correction *
Check power source and connections.
Release emergency stop switch by
rotating clockwise (check both switch
locations).
Tighten nut to secure stationary roll.
Inspect gears; repair/replace as
needed.
Adjust idler (rear) roll as needed until
idler roll is parallel to stationary (top)
roll.
Use materials within machine's
capacity.
Inspect idler roll; make adjustments as
needed.
12
Advertisement
Table of Contents
