Table of Contents
Advertisement
8.4 General procedure
1.
Remove or add clamping fingers as needed for
width of material and type of bend.
2.
Adjust for setback and clamping pressure.
3.
Position stop bolt if needed.
4.
Align material in machine and press foot pedal
until it locks.
5.
Raise bending leaf to desired angle.
10.0 Troubleshooting
Trouble
Bends created with
great difficulty.
Clamping leaf will not
clamp properly.
Bend radius not
consistent across
material.
11.0 Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-
800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and Serial
Number of your machine available when you call will allow us to serve you quickly and accurately.
Probable Cause
Machine capacity exceeded.
Incorrect setback.
Improper adjustment.
Clamping not even across width.
Machine capacity exceeded.
Bending leaf edge not parallel to fingers.
Bending leaf has crown.
6.
Lower bending leaf and press foot pedal lock
to release material.
9.0 Maintenance
Daily wipe down machine with a soft rag.
Apply a light coat of SAE 30 oil to exposed metal
surfaces to prevent rust.
Daily insert grease into the two fittings (14).
Remedy
Use material within capacity.
Increase setback.
Decrease distance between fingers and
beam.
Rotate adjustment knobs equal amount.
Use material within capacity.
Adjust bending leaf equally on both ends.
Correct with crown adjustment rod.
Table 1
8
Advertisement
Table of Contents
