Table of Contents
Advertisement
VIPA System SLIO
PM - Power module
Fusing
State of the electronic
power supply via LEDs
HB300 | IM | 053-1EC00 | en | 16-49
For wires with a core cross-section of 0.08mm
Pos.
Function
1
---
2
DC 24V
3
0V
4
Sys DC 24V
5
---
6
DC 24V
7
0V
8
Sys 0V
I: Input
CAUTION!
Since the power section supply is not internally protected, it is to be exter-
nally protected with a fuse, which corresponds to the maximum current.
This means max. 10A is to be protected by a 10A fuse (fast) respectively
by a line circuit breaker 10A characteristics Z!
The electronic power section supply is internally protected against higher
voltage by fuse. The fuse is within the power module. If the fuse releases,
its electronic module must be exchanged!
n
The power section supply is to be externally protected with a fuse, which corresponds
to the maximum current. This means max. 10A is to be protected with a 10A fuse
(fast) respectively by a line circuit breaker 10A characteristics Z!
n
It is recommended to externally protect the electronic power supply for head modules
and I/O area with a 2A fuse (fast) respectively by a line circuit breaker 2A characteris-
tics Z.
The electronic power supply for the I/O area of the power module 007-1AB10 should
n
also be externally protected with a 1A fuse (fast) respectively by a line circuit breaker
1A characteristics Z.
After PowerON of the System SLIO the LEDs RUN respectively MF get on so far as the
sum current does not exceed 3A. With a sum current greater than 3A the LEDs may not
be activated. Here the power module with the order number 007-1AB10 is to be placed
between the peripheral modules.
2
up to 1.5mm
Type
Description
---
not connected
I
DC 24V for power section supply
I
GND for power section supply
I
DC 24V for electronic section supply
---
not connected
I
DC 24V for power section supply
I
GND for power section supply
I
GND for electronic section supply
Basics and mounting
Wiring > Wiring power modules
2
.
23
Advertisement
Table of Contents
