Table of Contents
Advertisement
VIPA System SLIO
PM - Power module
Interface for EtherCAT
communication
3.2.2 LEDs
LEDs power module
HB300 | IM | 053-1EC00 | en | 16-49
For wires with a core cross-section of 0.08mm
Pos.
Function
1
---
2
DC 24V
3
0V
4
Sys DC 24V
5
---
6
DC 24V
7
0V
8
Sys 0V
I: Input
8pin RJ45 jacks:
n
An EtherCAT network always consists of a master and an various number of
EtherCAT salves (coupler).
n
Each EtherCAT slave has an "IN" and "OUT" RJ45 jack. The arriving EtherCAT cable
from the direction of the master is to be connected to the "IN" (Port 0) jack. The
"OUT" (Port 1) jack is to be connected to the succeeding EtherCAT station. With the
respective last EtherCAT station the "OUT" jack remains free.
n
EtherCAT uses Ethernet as transfer medium. Standard CAT5 cables are used. Here
distances of about 100m between 2 stations are possible.
n
Only EtherCAT components may be used in an EtherCAT network. For topologies,
which depart from the line structure, the corresponding EtherCAT components are
necessary.
n
Hubs may not be used.
PWR IO
PWR
green
green
●
X
●
●
X
X
on: ● | off: ○ | not relevant: X
2
up to 1.5mm
Type
Description
---
not connected
I
DC 24V for power section supply
I
GND for power section supply
I
DC 24V for electronic section supply
---
not connected
I
DC 24V for power section supply
I
GND for power section supply
I
GND for electronic section supply
PF
Description
red
○
Power section supply OK
○
Electronic section supply OK
●
Fuse electronic section supply defective
Hardware description
Structure > LEDs
2
.
37
Advertisement
Table of Contents
