Start-Up Procedure - Protocol AeroDrone Instruction Manual

START-UP PROCEDURE

Before flying, the drone and transmitter must be turned on in sequence
and synchronized.
1. Turn on the drone and place it on an even surface. The blue lights on the
drone are at the front and the yellow are at the back.
2. Turn on the remote control. The remote will beep to show a connection and
the lights on the drone will go steady. After five seconds of inactivity, the
drone's lights will slowly start to flash.
3. Push the throttle up and then down to sync. You will hear two beeps and
the lights will go steady to indicate the drone has synced.
4. Your drone is now synchronized, and in stand-by mode awaiting Engine
Idle command.
NOTE:
If after 30 seconds, it has not recognized the drone, turn off the controller
and repeat Start-Up procedure.
STARTING THE ENGINE; ENGINE IDLE
After synchronizing the drone, move the throttle and direction sticks to the lower
outer corners and release to go into Idle mode. The blades will rotate but the drone
will not lift.
OR
Push the throttle up and release to go into Idle Mode.
6