Start-Up Procedure - Protocol Kaptur Instruction Manual

START-UP PROCEDURE

Before flying, the drone and transmitter must be turned on in sequence
and synchronized.
1. Turn on the drone and place it on an even surface. The white lights on the
drone are at the front and the red are at the back.
2. Turn on the remote control.
3. Both indicators on the drone and the remote will flash while they are syncing.
4. Push the throttle up and then down to sync. You will hear two beeps and the
lights will go steady.
NOTE:
1. While the drone is in process of synchronizing, the lights will flash
quickly. When the process is completed, the lights will go steady.
This is your indication that the process is completed.
2. If after 30 seconds, it has not recognized the drone, turn off the controller
and repeat Start-Up procedure.
3. If the Kaptur is unsteady in flight, it may not have been able to calibrate
properly. Power down both drone and remote and restart pre-flight
procedure, including re-calibration of the altitude sensor.
6