Fitting The Starter System - PEUGEOT XS1P52QMI-4 Workshop Manual

PRIMARY TRANSMISSION

Fitting the starter system

- Fit the return spring (4), hook the longest
buckle on the cover's pin (A).
- Fit the starter gear sector (1) into the
lubricated bearing sleeve.
- Hook the second buckle (B) of the spring onto
the starter gear sector.
- Wind the spring so as to position the kick
starter sector on the stop (C) of the cover.
- Turn over the cover, fit the washer and the
circlip on the the gear sector spindle.
- Fit the washer (5) on the housing of the kick
starter drive piece.
- Wind approximately 1/8th of a turn the gear
sector so as to place the kick starter drive
piece (2).
- Position the pin (6) on the kick starter drive
piece in the cover housing (D).
16
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
B
4
D
6
5
2
1
C
A