Monitoring Menu - Vacon 20 X Installation, Technical And Maintenance Manual

Options
8.4.5

Monitoring menu

Monitoring values are actual values of measured signals as well as status of some control settings.
It is visible in Vacon 20CP display, but it can not be edited. The monitoring values are listed in the
Application Manual.
RE ADY RU N
REF
M ON
PAR
SYS/ FLT
FWD R EV
Press OK to enter
1
Monitoring menu
RE ADY RU N
REF
M ON
PAR
SYS/ FLT
FWD R EV
Prsess Down to
3
browse V4.5
RE ADY RU N
RE F
M ON
PAR
SYS/ FLT
FWD R EV
Pressing Left/Right button to change the actual parameter to the first parameter of the next group,
to browse monitor menu from V1.x to V2.1 to V3.1 to V4.1. After entering the desired group, the mon-
itoring values can be browsed by pressing UP/DOWN button, as shown in Figure 48. In MON menu
the selected signal and its value are alternating in the display by pressing OK button.
Note! Turn on drive power, arrowhead of main menu is at MON, V x.x or monitor parameter value
of Vx.x is displayed in Panel. Display Vx.x or monitor parameter value of Vx.x is determined by the
last show status before power shut down.
Service support: find your nearest Vacon service center at www.vacon.com
S TOP ALARM FAULT
I/O K EYPAD BUS
OK
S TOP ALARM FAULT
I/O K EYPAD BUS
S TOP ALARM FAULT
OK
I/O K EYPAD BUS
Figure 48. Monitoring menu.
RE ADY RU N S TOP
RE F
M ON
PAR
SYS/ FLT
FWD R EV I/O
Press Left/Right to browse
2
other Monitoring groups
RE ADY RU N S TOP
RE F
M ON
PAR
SYS/ FLT
FWD R EV I/O
OK
Preess OK the value is
4
displayed
Press OK V4.5 is display
5
vacon • 76
ALARM FAULT
K EYPAD BUS
ALARM FAULT
K EYPAD BUS
8