Monitoring Menu - Vacon 20 X Installation, Technical And Maintenance Manual

vacon • 61
7.4.5

Monitoring menu

Monitoring values are actual values of measured signals as well as status of some control settings.
It is visible in Vacon 20 X display, but it can not be edited. The monitoring values are listed in the
Application Manual.
READY RU N
REF
MON
PAR
SYS/ FLT
FWD
1
Press OK to enter
Monitoring menu
READY RU N
REF
MON
PAR
SYS/ FLT
FWD
3 Press Down to
browse V4.5
READY RU N
REF
MON
PAR
SYS/ FLT
FWD
Pressing Left/Right button to change the actual parameter to the first parameter of the next group,
to browse monitor menu from V1.x to V2.1 to V3.1 to V4.1. After entering the desired group, the mon-
itoring values can be browsed by pressing UP/DOWN button, as shown in Figure 30. In MON menu
the selected signal and its value are alternating in the display by pressing OK button.
Note! Turn on drive power, arrowhead of main menu is at MON, V x.x or monitor parameter value
of Vx.x is displayed in Panel. Display Vx.x or monitor parameter value of Vx.x is determined by the
last show status before power shut down.
7
STOP ALARM FAULT
R EV I/O K EYPAD BUS
OK
STOP ALARM FAULT
R EV I/O K EYPAD BUS
STOP ALARM FAULT
OK
R EV I/O K EYPAD BUS
Figure 30. Monitoring menu.
READY RU N STOP ALARM
REF
MON
PAR
SYS/ FLT
FWD R EV I/O K EYPAD BUS
Press Left/Right to browse
2
other Monitoring groups
READY RU N STOP ALARM
REF
M ON
PAR
SYS/ FLT
FWD R EV I/O K EYPAD BUS
OK
Press OK to select
4
V4.5
Press OK to display
5
the value
Options
FAULT
FAULT