Emptying/Replacing Collection Drum Bag - Grizzly G0860 Owner's Manual

6. With assistant holding canister filter from
below, loosen and remove (6)
flange bolts securing canister filter assembly
to impeller housing (see Figure 72).
Figure 72. Remove flange bolts to remove
canister filter assembly from impeller housing.
7. Vacuum loose dust inside impeller housing
and on machine.
8. Reverse Steps 2–6 to re-assemble.
Emptying/Replacing
Collection Drum Bag
Dust
while
may cause cancer, birth
defects, or long-term respi-
ratory
wear goggles and a NIOSH-
approved respirator when
working with the dust col-
lection bags or canisters.
Dispose of the collection drum bag when dust fills
it ⁄ full. Replace the bag if it develops a leak or
3
4
becomes damaged.
Model G0860/G0861/G0862 (Mfd. Since 10/18)
⁄ "-18 x ⁄ "
5 3
16 4
x 6
exposure created
using machinery
damage. Always
Items Needed
Drum Bag T27974 (Models G0860, G0861) ...... 1
Drum Bag T28454 (Model G0862) .................... 1
To remove and replace collection drum bag:
1. DISCONNECT MACHINE FROM POWER!
2.
Lift drum lock handle to lower collection drum
onto casters (see Figure 73).
3.
Release both latches on sides of drum, then
roll drum clear of drum lid (see Figure 73).
Drum Lock
Handle
Drum Lid
Drum Bag
Latch
(1 of 2)
Figure 73. Collection drum bag components.
4. Lift bag out of drum and dispose of contents.
IMPORTANT: To contain wood dust and min-
imize risk of exposure, tie bag closed before
disposal.
5. Place new dust bag inside collection drum,
and fold excess bag length over top of drum.
6. Move collection drum under lid and latch it
closed.
7. Press drum lock handle down to lift collection
drum off casters for operation.
Qty
-45-