Grizzly G0860 Owner's Manual page 26

30. Loosen (2) Phillips head screws and remove
magnetic switch cover (see Figure 28).
Phillips
Head
Screws
Figure 28. Magnetic switch cover.
31. Install magnetic switch over FIX SWITCH
HERE label (left support arm for Models
G0860 and G0861, right support arm for
Model G0862), then secure with (2) 10-24 x
⁄ " Phillips head screws and (2) 10-24 hex
3
4
nuts (see Figure 29).
x 2
Figure 29. Installing magnetic switch on support
arm.
-26-
32. Tuck loose wires into magnetic switch cover
so none can be crimped when cover is re-
attached, and then replace magnetic switch
cover and tighten (2) Phillips head screws
loosened in Step 30 to secure.
33. Thread motor cord through support arm open-
Magnetic
ing and connect to matching plug from motor
Switch
under impeller housing (see Figure 30).
Cover
Support Arm
Opening
Figure 30. Magnetic switch attached to support
34. Install inlet adapter on dust port and
Figure 31. Inlet adapter installed on dust port.
Model G0860/G0861/G0862 (Mfd. Since 10/18)
arm.
secure with 10-24 x
3
Figure 31).
Motor
Cord
⁄ " flange screw (see
8
Inlet
Adapter
x 1