Table of Contents
Advertisement
S S w w i i t t c c h h i i n n g g o o n n
• Check the setting of the circuit breaker. (see
chapter " Fuse / Over-current Release ")
• To switch the unit on, turn the key switch in
horizontal position. The green power LED lights
up.
T T e e m m p p e e r r a a t t u u r r e e D D i i s s p p l l a a y y
• During normal operation the display shows the
internal temperature of the refrigerator. The
temperature unit is dependent on the setting
"TEMP.UNIT" in the SETTINGS menu.
(°C - Celsius or °F -Fahrenheit).
B B u u t t t t o o n n f f u u n n c c t t i i o o n n s s
• Pressing the M M E E N N U U - - b b u u t t t t o o n n
to the menu area. Choose the respective menu
using the UP- and DOWN-keys. The selection is
confirmed with the ENTER-button.
• Press the BACK-key
previous screen or menu.
• Navigation within the menus and changing of the
settings are done using the U U P P
L L E E F F T T - -
u u n n d d R R I I G G H H T T
S S e e t t t t i i n n g g t t h h e e l l a a n n g g u u a a g g e e
• The factory language setting of the electronics is
ENGLISH. To convert to another language,
proceed as follows :
T T h h e e " " S S E E T T T T I I N N G G S S " " - - M M e e n n u u
• The parameters contained in the "SETTINGS" menu partially intervene in the function
of the appliance. Access to the SETTINGS menu can therefore be protected by a
password. It is recommended to use this protection to limit access to the parameters.
press the MENU-key
select "SETTINGS"
USER PASSWORD :
0XXX
SET POINT
SET : X.X °C
gives you access
to return to the
, , D D O O W W N N - -
, ,
keys.
• After the self-test, the temperature inside the
refrigerator is displayed.
• The compressor will only switch on a certain time
after the self-test.
• The display is carried out in steps of 0.1° or 1°
- depending on the setting "RESOLUTION" in the
SETTINGS menu.
• Use the E E N N T T E E R R - - k k e e y y
selection. This applies both for menu selection
and for parameter value. The change of a
parameter only becomes effective when
confirmed with the ENTER-key.
• In the case of an alarm, the acoustic alarm can be
switched off for a specified time with the "m m u u t t e e
b b u u t t t t o o n n ". In Menu-mode the "mute button" is out
of function.
press the MENU-key.
select EXTRA
LANGUAGE
select your language
In the factory setting this password is set to the value
"0000" so that by pressing the
directly into the SETTINGS menu.
The temperature set point is the set temperature of the
refrigerator. The set point can be altered
between the prescribed limit values in stages of 0.5 K.
to confirm the actual
- button you get
7
Hide quick links:
Advertisement
Table of Contents
