Dometic UF 755G Operating Instructions Manual page 8

DATE/TIME
SET DATE/TIME
HH:MM
dd MMM yy
SELECT 12h/24H
M
12h DISPLAY
ALARMS
SET LOW ALARM
LOW ALARM : X.X °C
SET HIGH ALARM
HIGH ALARM : X.X °C
REMOTE DOOR ALARM
REMOTE DOOR ALARM
ENABLE : 0
FRAME HEATER
FRAME HEATER OFF
ALARM TEST
ALARM TEST ACTIVATION
ALARM TEST
REMOTE ACTIVATION
REMOTE OFF
COMM. ADDRESS
COMM. ADDR: 0
SERVICE
RESET SERVICE TIME
RESET COUNTER
YES
HIDE SERVICE WARNING
8
24h DISPLAY
1
ON
ON
255
NO
Setting current time and date.
Changing between 12-hour and 24-hour display
The lowest admissible internal temperature. If the
temperature falls below this value a temperature alarm
is triggered.
The highest admissible internal temperature. If the
temperature exceeds this value a temperature alarm is
triggered.
Activation of the remote alarm on opening door
0 = remote alarm off / 1 = remote alarm on.
Switching frame heater on and off.
(see Chapter " Frame heater ")
This function is used for simulation a temperature alarm
situation. Pressing the ENTER-button will launch the
following alarm test cycle:
1. Phased increase of the internal temperature until the
upper alarm limit is reached. Triggering of the
temperature alarm.
2. Phased reduction of the internal temperature until
the lower alarm limit is reached. Triggering of the
temperature alarm.
The remote alarm function can be switched on and off
for an alarm test.
With the aid of the built-in RS485 interface several
appliances can be networked with each other. If this is
the case every individual appliance must receive a
separate communication address.
(setting of 0 – 255)
After the expiry of a given operating time a "SERVICE"
message appears on the display to call attention to the
fact that a regular maintenance is due. The counter for
this service time can be put back with this function.
This function is for cancelling the "service"
message.