Table of Contents
Advertisement
web: This field enables or disables the built in web management utility. You can select either "on" or "off"
to enable or disable it.
6.5 Null Modem Cable Configuration
9 pin female connector
pin 5 <==============> pin 5
pin 3 <==============> pin 2
pin 7 <==============> pin 8
pin 6 <==============> pin 4
pin 2 <==============> pin 3
pin 8 <==============> pin 7
pin 4 <==============> pin 6
6.6 Diagnostic Methods
1. When the "power" LED of the Access Point does not illuminate, make sure that the power cord is fully
seated in the socket on the rear panel of the unit.
2. When the "alert" LED continuously illuminates or blinks, check the states of the radio card (SWL
-1000N) installed in the Access Point. Unplug and re-plug POWER (OFF/ON again).
3. If the "alert" LED continuously illuminates or blinks, please contact your local service center or the
retailer
where you purchased the units.
Default: "on"
9 pin female connector
< Ground - Ground
< Transmit - Receive >
< RTS - CTS >
< DSR - DTR >
< Receive - Transmit >
< CTS - RTS >
< DTR - DSR >
63
>
Advertisement
Table of Contents
