Table of Contents
Advertisement
CMD: set AP_name WLAN_AP (Access Point Name)
CMD: set channel 1 (RF channel)
CMD: set IP_address 123.45.67.8 (origin IP of the AP)
CMD: set gateway 123.45.67.1
CMD: set mode structurenet
CMD: set Telnet on/off (for telnet connection)
CMD: set Web on/off (for http connection)
CMD: set standard on (for interoperability)
4. After you set all the parameters for your system, execute "restart" command to make the changes
take effects.
5. Now your AP is ready to be used.
6.4 Parameter Setup
• RADIO RELATED
channel: This field specifies the operating channel for the SWL-2000AP. The SWL-2000AP allows from 1
to 13 but the channels used by adjacent AP should be apart by more than 5 channels. For example, if an AP
uses channel 1, the adjacent AP should use channel 6 or higher for the best output.
RTS_threshold: This field determines the size of RTS(Request-To-Send)/CTS(Clear-To-Send) frames and
the frames to be used.
short_retry: This field specifies the number of transmissions of RTS/CTS to be attempted before aborting
when the communication between clients is interfered. Note that RTS/CTS are delivered back and forth
between the clients to monitor the channel for the possibility of communications.
long_retry: This field specifies the number of trials of data transmission when the channel or a client causes
the cease of data transmissions.
Standard: This field is used for interoperability between multiple IEEE 802.11 venders.
Default: 1
Default: 2301
Default: 15
Default: 15
Default: on
61
Advertisement
Table of Contents
