Miele B 3312 Operating Instructions Manual page 73

Message
Message in the display:

Boiler fault, cold Switch
off/on

Release stm. button
Message in the display:

Drainage fault Switch
off/on
Cause and remedy
There is a fault.
 Press the  button to switch the steam ironing
system off and then back on again.
 If the fault continues to be displayed, contact your
Miele dealer.
The iron has switched itself off because it has not
been used for a period of time and the steam
button  has locked.
 Unlock the steam button  by pushing the slider
for continual steam on the iron forwards.
The residual water drawer has not been detected.
 Press the  button to switch the steam ironing
system off and then back on again.
After switching the steam ironing system off and back
on, the residual water drawer has not been detected.
 Press the  button to switch the steam ironing
system off.
 Clean and dry the metal discs (contacts) on the
residual water drawer.
 Use the  button to switch the steam ironing
system back on and follow the instructions shown
in the display:
 Remove the residual water drawer and fill it with
fresh tap water.
 Put the filled residual water drawer back in the
tower.
 Remove the residual water drawer again when you
are prompted to do so and the appropriate
messages are shown in the display.
 Empty and dry the residual water drawer.
 Put the empty residual water drawer back in the
tower.
The steam ironing system is now ready for operation
and will continue to operate from the point reached
before the fault was registered.
There is a fault.
 If the fault message continues to be displayed,
contact your Miele dealer.
Problem solving guide
73