Miele B 3312 Operating Instructions Manual page 68

Problem solving guide
Issue
The iron does not heat
up.
The ironing board is not
heated.
68
Cause and remedy
The steam ironing system is switched off.
 Use the  button on the control panel to switch
the steam ironing system on.
The steam hose is not plugged in properly.
 Plug the steam hose into the steam connection on
the tower again (see „Connection").
The iron has not been used for some time.
 Move the iron or activate the steam button .
The steam button  is locked.
 Unlock the button by pushing the slider on the iron
forward.
The temperature set on the temperature controller has
already been reached.
 Set the temperature controller to a higher
temperature, if necessary.
The steam ironing system is rinsing.
 Wait until the rinsing process has been completed
(see „Automatic rinsing").
The display is indicating a malfunction.
 Rectify the indicated malfunction and proceed as
described in the following pages (see „Display
messages").
The steam ironing system is damaged.
 Contact your Miele dealer.
Steam has not been used for a while.
 Press the steam button . This will activate the
ironing board's heating system.
The steamer is attached to the steam connection on
the tower.
 The ironing board does not heat up when the
steamer is connected.
The ironing board is not locked into place on both
sides of the tower.
 Ensure the ironing board locks into place on both
sides of the tower (see „Assembly")
The steam ironing system is damaged.
 Contact your Miele dealer.