Advertisement
MASKINFABRIK
HARALDSVEJ 21
DK-8900 BANDERS
TLF.-t-45 86 43 51 55
FAX. + 45 86 43 51 00
Instructions manual
MORS0 Mitring machine
Model F
FUNCTIONAL DESCRIPTION B-4
picture B-4-1
I
Beware of the extreme
sharp knives
DESCRIPTION OF CUTTING
The knife block (1) is in top position and the
slide frame (3) in the rear position.
Working with a moulding with rebate the
rebate supports (2) are adjusted to the height
of the rebate.
The forward movement is adjusted manually
with handle (4) to a suitable starting position
on the moulding.
The pedal (5) is pressed home, then relieve
the foot pressure so that the springs take the
knife block (1) back to top position.
The handle (4) is now moved a suitable
distance forward (depending on the hardness of
the wood) in the tooth arc (6), and you make
the next cut.
Proceed in this way until the moulding is cut
through.
The last cut must always be a small cut. The
tooth arc is constructed so that the last tooth
only has half travel compared to the other
teeth.
Even with small mouldings you must make the
last small cut in order to achieve a good
result.
MORS0 F -9503 B-4/gb1
Advertisement
