Advertisement
^ ! rclJan-list'*
MK
" HARALDSVEJ21
DK-8900 RANDERS
TLF. + 45864351 55
FAX.
+ 45 86 43 51 00
Instructions manual
MORS0 Mitring machine
Model F
OPERATING INSTRUCTIONS
E-4
picture E-4-1
I
Beware of the extreme
sharp knives
MORS0 F -9503 E-4/gb1
16
ADJUSTMENT OF LENGTH OF MOULDING
Principle:
The inside measures of
measures less 2 times
a frame = outside
the
width of
the
width
moulding (if both ends are cut at 45°.)
The width of the moulding is measured by
means of the transverse measuring scale (2)
on the table (1).
on the table (1).
The length of the moulding is measured by
means of the measuring scale (3) on the table
(1) and the measuring scale (4) on the stop
beam (5).The measuring scale (4) on the stop
beam (5) is carried out in double measures.
Example 1:
Outside measures of the frame:
1. Star wheel (7) on stop block (6) is
loosened.
2. The required length of moulding is 29 cm.
The mark "0" on scale (4) on stop beam
(5) is adjusted exactly opposite the 29 cm
mark on the measuring scale (3) on the
table.
The outside measures of the frame will be
29 cm.
3. Star wheel (7) is fastened.
Example 2:
Inside measures of the frame:
1. Star wheel (7) on the stop block (6) is
loosened.
2. The width of the moulding, excl. the
rebate (e.g. 3.5 cm) is read on the
transverse scale (2) on the table.
3. The required length of moulding is 27 cm.
The 3.5 cm mark on scale (4) on the stop
beam (5) is adjusted exactly opposite the
27 cm mark on the measuring scale (3) on
the table.
The inside measures of the frame will be
27 cm.
4. Star wheel (7) is fastened.
_J
Advertisement
