Advertisement
MASKINFABRIK
HARALDSVEJ 21
DK-8900 RANDERS
TLF. -1-45864351 55
FAX. + 45 86 43 51 00
Instructions manual
MORS0 Mitring machine
Model F + H
©
picture L-1-3-1
picture L-1-3-2
Accessories
L-1-3
Beware of the extreme
sharp knives
MORS0 F+H -9503 L-1-3/gt>1
REBATE SUPPORT ATTACHMENT,
AUTOM.
Adjustment of Rebate Supports
The knife block must be in top postion during
the adjustment.
The rebate supports are
only used
when
cutting mouldings with rebate.
To adjust the rebate support star wheel (1)
and knurled nut (2) are loosened.
Place the moulding in the machine. Push the
rebate supports (4) into the rebate of the
moulding.
Press the moulding down on the
machine
table.
The height of the rebate supports is adjusted
by means of the knurled nut (3). The rebate
supports must be adjusted so that they are
approx. 1/2 mm under the rebate of the
moulding.
After the adjustment the knurled nut (2) is
fastened.
The rebate supports are fastened
with star
wheel (1) so that they have a distance of
about 1/2 mm from the moulding.
The rebate supports can be removed from the
machine
when the knife block is in the rear
position.
41
Advertisement
