Advertisement
MASKINFABRIK
HARALDSVEJ 21
DK-8900 RANDERS
TLF. + 4 5 8 6 4 3 5 1 55
FAX. -t- 45 86 43 51 00
Instructions manual
MORS0 Mitring machine
Model F
OPERATING INSTRUCTIONS E-3
®
picture E-3-1
picture E-3-2
Beware of the extreme
sharp knives
DEGREE ADJUSTMENT OF FENCES
The fences (1) + (2) are adjusted as required
(from the factory they are adjusted to 45 for
double mitre).
If, for instance, you want to make a 6-sided
(hexagonal) frame the following procedure is
used:
6 pieces of moulding are cut in the normal
way at 45
so that the inside measure of
each
piece
of
moulding is equal to
the
finished inside measure of the frame
the width of the rebate.
plus
approx.
Hand levers (3) and (4) are loosened and the
fences are turned according to the scales (5)
and (6) to 6(T
o
The degree adjustment
the mark (7).
is read by means of
After the adjustment the hand levers (3) and
(4) are fastened again, and all moulding ends
a cut separately at 60 - single mitre.
EXACT ADJUSTMENT OF THE FENCES:
When the fences have been adjusted to other
degrees than 45 the correct re-adjustment to
45 is made as follows:
Put a straight steel ruler (8) against the
measuring scale (9) so that it also reaches
along the right fence (2). Now you adjust the
right fence (2) according to the steel ruler,
and
the
right
adjusted at 45 .
fence
(2) will
be
exactly
Put the steel ruler (8) against the right fence
(2) (that is now exactly adjusted at 45 ), and
proceed as mentioned above with the adjust-
ment of the left fence (1).
15
Advertisement
