Advertisement
MASKINFABR
HARALDSVEJ 21
DK-8900RANDERS
TLF. + 45 86 43 51 55
FAX. + 45 86 43 51 00
Instructions manual
MORS0 Mitring machine
Model F
picture E-6-1
•
I
UPERATING INSTRUCTIONS
E-6
Beware of the extreme
sharp knives
MORS0 F -9503 E-6/gb1
18
ADJUSTMENT OF HEIGHT STOP
The height stop (1) is used for adjustment of
the
knife block (2) to
a suitable height
compared to the moulding to be cut.
In this way you avoid unnecessary high foot
movements.
The moulding is placed on the table (the knife
block must be in the rear position, as shown
on the picture). The knife block (2) is moved
forward to the front position by means of
handle (3).
With the foot pedal (4) the knife block (2) is
moved down to the height required, yet min.
20 mm above the moulding.
The height stop (1) is loosened with handle
(6), which can be removed from the fence.
Fasten the height stop against the foot pedal
tipper (5).
The height stop is also used for locking the
knife block in the bottom position when the
machine is not used.
Advertisement
