Advertisement
•
I
I
MASKINFABRIK
HARALDSVEJ21
DK-8900 RANDERS
TLF.+ 45864351 55
FAX. + 45 86 43 51 00
Instructions manual
MORS0 Mitring machine
Model F
picture F-1
picture F-2
I
Beware of the extreme
sharp knives
Service
F-4
REGULATION OF DRAW BAR
As the knives are worn it will be necessary to
adjust the draw bar (1).
The following procedure is used:
1. The foot pedal (2) is pressed home and
locked by means of the height stop (3).
2. Loosen nut (4).
3. Nut (5) is screwed so much upwards that
the knife edge goes about 4 - 6 mm under
the upper side of the bottom knives.
5. Fasten nut (4) against the draw bow (6).
ADJUSTMENT OF FORWARD MOVEMENT
When you have changed used knives it might
be necessary to adjust the forward movement.
1. The knife block unit is placed in the front
position with handle (7) (on the picture it
is shown in the rear position).
The fences (8) + (9) must be adjusted
on standard (45 ) position and be fastened.
2.
Loosen nut (10).
3. Bushing (11) is turned with a spanner until
the front point of the knives goes a little
bit between the fences (8) + (9) , but the
knives must not touch the fences.
4.
Fasten nut (10) while holding the bushing
(11) in the adjusted position by means of
the spanner.
The position of the knives is checked by
moving the knife block down slowly. If the
fences (8) + (9) are
not
touched, put
a
moulding in the machine and cut it. If the
moulding does not split on the front edge the
adjustment is correct.
MORS0 F -9503 F-4/gb1
23
Advertisement
