Advertisement
MASKINFABRIK
HARALDSVEJ 21
DK-8900 RANDERS
TLF.-1-45 86 43 51 55
FAX. + 45 86 43 51 00
Instructions manual
MORS0 Mitring machine
Model F
picture D-1-1
I
MOUNTING INSTRUCTIONS
D-1
Beware of the extreme
sharp knives
IN GENERAL
The machine is delivered ready for start and
complete with standard equipment.
Only the table extension (1) and divided beam
(5) are dismounted during transport.
NOTE before starting up first time:
1. Remove the locking pin in the machine
table (marked with a yellow/black wing).
2. The knife block is moved halfway
backwards, and the slide is fitted.
Placing according to the spaciousness to wall
stated in C-l.
The machine can be fastened to the floor
with screws in the two holes in the bottom
frame of the machine.
Check before each start that all protection
devices are fitted correctly.
MOUNTING OF THE TABLE EXTENSION
AND
DIVIDED BEAM
Before mounting the table extension (1) the
ends of the table extension and the table (2)
must be cleaned very thoroughly.
Special attention must be paid to the pin and
screw holes as the smallest amount of dirt
will prevent the correct alignment.
After the cleaning the table extension is
pressed against the table so that the pins (4)
placed in the table extension are inserted in
the pin holes in the table.
Then the included screw (3) is inserted in the
screw hole and fastened with a standard screw
driver (nv= 19 mm).
The divided beam (5) is fitted on the table
extension (pins (6) are fitted in the table
extension). It is fastened with cylinder screw
(7).
(Extra extension table and supporting leg can
be delivered as accessories).
MORS0 F -9503 D-1/gb1
12
Advertisement
