Advertisement
MASKINFABHIK
HARALDSVEJ 21
DK-8900 RANDERS
TLF. + 45 86 43 51 55
FAX. + 45 86 43 51 00
Instructions manual
MORS0 Mitring machine
Model F
picture F-6-1
Service
F-6
Beware of the extreme
sharp knives
ADJUSTMENT OF HEIGHT MOVEMENT
The height movement of the knife block (1) is
adjusted to max. 165 mm from the factory.
In the following way the machine can be ad-
justed to a height movement of max. 200 mm:
1. The knife block unit (2) is placed in the
rear position.
2. A piece of wood is put on the table (3)
under the knives in order to prevent that
the knife block (1) will fall down during
the adjustment.
3. The springs (4) is pulled out of the spring
holders (5) and draw bow holders (6).
4. The draw bow holders (6) placed in the
rear holes in the foot pedal tipper (7) are
moved to the front holes in the foot pedal
tipper (7).
5. Fasten the draw bow holders (6) in the
draw bow (8) again.
6. Place the springs (4) in the spring holders
(5) and the draw bow holders (6).
7. The draw bar (9) is adjusted as described
under F-4.
MORS0 F -9503 F-6/gb1
25
Advertisement
