Using A Switch With User Begin - HP 8712ET User Manual Supplement

9. To verify your change, select
10. Select the first softkey which should be labeled "Setup 1". This should
11. You may save this program as an AUTOST file or other file for later
Refer to the HP Instrument BASIC User's Handbook Supplement.

Using a Switch with User BEGIN

When user-defined
connected to the USER TTL IN/OUT rear-panel connector, you can cycle
through up to seven softkeys in sequence by activating the switch.
1. Connect a switch to the USER TTL IN/OUT rear panel connector as
Figure 3-2 Connecting a Switch to the USER TTL IN/OUT Connector
Automating Measurements
User BEGIN ON .
return you to your correct setup.
recall.
BEGIN
shown in Figure 3-2.
User-Defined BEGIN Key Menu
PRESET BEGIN
is used in conjunction with a switch
Operator Interaction
3-11