Purge Setting On Commission; Commissioning—Set Lightoff; Start Lightoff; Commissioning Curve—Delete Points - Honeywell S7999B Manual

6. Quit
• Press this button when done with the curve at this
point. The following buttons display:
a. Back:
• Press to return to the Commission Configuration
screen.
b. Home:
• Go to Home page.
c. Finish:
• Press to save the profile you have created. The
Finish button is grayed out until you complete the
profile. After you press this button, the Monitor
screen is displayed. You can exit the program from
there.
d. Save:
• Save Curve S7999B flash (Fig. 37 and 38). Control
returns to Curve Commission screen.
e. Cancel:
• Cancel Quit and continue curve configuration.
The following screens depict the options possible to create or
change the profile curve for the currently selected fuel. The
operation of this screen is explained in the Commission Curve
screen, defined earlier.
Curve commissioning can only occur after all actuators have
been completely configured and locked. The Next button on
the Commission Configuration screen is not enabled until this
is true. Once the actuators are configured, the Next button
brings the user to the Curve Commissioning screen.
NOTE: The Load Curve button also brings the user to this
screen. It is also only enabled after the actuators
have been configured.
Fig. 33. Start lightoff.
Fig. 34. Purge setting on Commission.
Fig. 35. Commissioning—set lightoff.
Fig. 36. Commissioning curve—Delete points.
29
S7999B SYSTEM DISPLAY
65-0283—2