3.5 Connecting to a LAN or Router
Status LED
Yellow
Installation Instructions
1) Connect an RJ45 patch cable to the Adapter (Cat 6 recommended for Gigabit Ethernet)
2) Connect the patch cable to a LAN or router port
3) Connect the Adapter to a Thunderbolt 3 port on the computer
4) Check the documentation of your LAN or router to configure network access
5) Link and Status LED's should blink to indicate a live connection
Troubleshooting Tips
Disconnect all cables, reboot the computer, and reconnect the cables and Adapter
•
Check that the Link and Status LEDs are lit (100/1000 Fast or Gigabit Ethernet)
•
Test by turning off all wireless connections
•
Update the Thunderbolt 3 drivers from the computer manufacturer
•
Test the patch cable with a different device or try another Ethernet port
•
Thunderbolt™ 3 Multiport Adapter with Dual HDMI®
RJ45
www.cablematters.com
6
Link LED
Green