TANNER Scientific TN50 Operating Instructions Manual page 24

8.5 FAST APPROACH TO SPECIMEN
Press to move the knife holder base towards the sample.
Press to move the knife holder away from the sample.
8.6 SLOW APPROACH TO SPECIMEN
Press to move the knife holder base slowly towards the sample.
8.7 THICKNESS ADJUSTMENT FOR TRIMMING
To change the trimming settings, press
or decrease the value.
8.8 THICKNESS ADJUSTMENT FOR CUT
To change the cutting thickness, press
8.9 TRIMMING OF SPECIMEN
Insert object holder.
Orientate specimen as desired.
Deactivate the hand wheel stop.
Release finger protection.
If Trim latching mode is activated, trimming function is
activated and deactivated by pressing
Activation of trimming function is displayed as
illustrated.
If Trim latching mode is deactivated, trimming function is activated by continuously
pressing .
Activation of trimming function is displayed as illustrated above.
Turn hand wheel evenly clockwise
Operating Instructions – TN50
continuously and press
or to increase or decrease the value.
--TRIM--
once.
Cha: -20 °C (-22)
or to increase
Trim: 19µm
QF: 0
24