Common Practice Hart Commands - Siemens SITRANS F US Protocol Manual

Table 4- 21
Description
Long Tag
Table 4- 22
Description
Configuration Change Counter
Table 4- 23
Description
Device Specific Status
Reserved for future use
4.2

Common Practice HART Commands

Introduction
The following tables list the Common Practice HART Commands for the SITRANS F US
Clamp-on Communication Module.
Commands
Table 4- 24
Description
PV Upper and Lower Range Units Codes
PV Upper Range Value
PV Lower Range Value
Table 4- 25
Description
Fixed Current Level (milliamperes)
Table 4- 26
Description
Primary Variable Units Code
F US Clamp-on Communications Protocol Manual
Hardware Installation Manual, 11/2015, A5E34981613-AC
Command 22 - Write Long Tag
Command 38 - Reset Configuration Changed Flag
Command 48 - Read Additional Device Status
Command 35 - Write Primary Range Values
Command 40 - Enter/Exit Fixed Current Mode
Command 44 - Write Primary variable Units
4.2 Common Practice HART Commands
Byte Format Comments/Value
0-31 Latin-1
Byte Format Comments/Value
0-1 U-16
Byte Format Comments/Value
<Profile Number>
0
0
1-8
Byte Format Comments/Value
<common tables>
0 Enum
1-4 Float
5-8 Float
Byte Format Comments/Value
<0 exits fixed current mode>
0-3 Float
Byte Format Comments/Value
<common tables>
0 Enum
HART Communications
43