Table 4- 4 Command 2 - Read Loop Current And Percent Of Range; Table 4- 5 Command 3 - Read Dynamic Variable And Loop Current; Table 4- 6 Command 6 - Writing Polling Address; Table 4- 7 Command 7 - Read Loop Configuration - Siemens SITRANS F US Protocol Manual

Table 4- 4
Description
Primary Variable Loop Current
Primary Variable Percent of Range
Table 4- 5
Description
Primary Variable Loop Current
Primary Variable Units
Primary Variable
Secondary Variable Units
Secondary Variable
Tertiary Variable Units
Tertiary Variable
Quaternary Variable Units
Quaternary Variable
Table 4- 6
Description
Polling Address of Device
Loop Current Mode
Table 4- 7
Description
Polling Address of Device
Loop Current Mode
Table 4- 8
Description
Primary Variable Classification
Secondary Variable Classification
Tertiary Variable Classification
Quaternary Variable Classification
F US Clamp-on Communications Protocol Manual
Hardware Installation Manual, 11/2015, A5E34981613-AC
Command 2 - Read Loop Current and Percent of Range
Command 3 - Read Dynamic Variable and Loop Current
Command 6 - Writing Polling Address
Command 7 - Read Loop Configuration
Command 8 - Read Dynamic Variable Classifications
4.1 Universal HART Commands
Byte Format Comments/Value
<units in milli-amperes>
0-3 Float
4-7 Float <range set in CMD 35>
Byte Format Comments/Value
<units in milli-amperes>
0-3 Float
< write units CMD 44 or 53>
4 Enum
5-8 Float <write PV variable CMD 51>
9 Enum <write SV Units CMD 53>
10-13 Float <write SV variable CMD 51>
14 Enum <write TV Units CMD 53>
15-18 Float <write TV variable CMD 51>
19 Enum <write QV Units CMD 53>
20-23 Enum <write QV Variable CMD 51>
Byte Format Comments/Value
0 U-8
1 Enum 0-disabled 1-enabled
Byte Format Comments/Value
0 U-8
1 Enum 0-disabled 1-enabled
Byte Format Comments/Value
0-not classified
0 Enum
0-not classified
1 Enum
0-not classified
2 Enum
0-not classified
3 Enum
HART Communications
39