Table Of Contents - Pepperl+Fuchs FieldConnex F2D0-MIO-Ex12.FF Series Manual

Multi-Input/Output Device
1 Introduction................................................................................. 5
1.1 Content of this Document ................................................................... 5
1.2 Target Group, Personnel...................................................................... 5
1.3 Symbols Used ...................................................................................... 5
2 Product Specifications............................................................... 7
2.1 Overview and Application ................................................................... 7
2.2 Modes of Operation ............................................................................. 7
2.3 Hazardous Area Installation and Use............................................... 10
3 Installation and Commissioning ............................................. 12
3.1 Mounting and Dismounting............................................................... 12
3.2 Hardware Installation......................................................................... 13
3.2.1 R8D0-MIO* Cable and Connection Information ............................... 13
3.2.2 F2 Housing Degree of Protection ..................................................... 16
3.2.3 Grounding and Shielding ................................................................. 19
3.2.4 Dip Switch Settings .......................................................................... 22
3.3 Firmware Download ........................................................................... 22
3.4 Commissioning in Valve Coupler Mode........................................... 23
3.5 Commissioning in Binary Input Mode ............................................. 26
3.6 Commissioning in Frequency or Counter Mode ............................. 26
4 Parameterization and Operation ............................................. 28
4.1 Introduction ........................................................................................ 28
4.2 Prerequisites ...................................................................................... 29
4.3 Device Identification .......................................................................... 30
4.4 Commissioning Procedure ............................................................... 30
3